Configuring Customer-Facing Interfaces in the VPWS Instance

You must configure one of the following types of interfaces as a member of the VPWS to transmit packets between the PE router and each CE device to which the PE router is connected:

• ATM (AAL5 VCC transport or ATM VCC cell transport)
• Cisco HDLC
• Ethernet (Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet)
• Frame Relay
• PPP
• VLAN and S-VLAN subinterfaces over Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interfaces

To configure a customer-facing interface for an VPWS instance:

1. Access Interface Configuration mode for a layer 2 interface for the VPWS on the PE router.

   host1(config)#interface fastEthernet 4/0

2. Configure the local and remote site IDs on the interface to specify the interface as a member of the VPWS L2VPN.

   host1(config-if)#l2vpn exampleco local-site-id 1 remote-site-id 2

   host1(config-if)#exit

3. Repeat for all customer-facing interfaces in the VPWS.

   host1(config)#interface fastEthernet 4/1

   host1(config-if)#l2vpn exampleco local-site-id 1 remote-site-id 3

   host1(config-if)#exit

Related Topics

• interface fastEthernet command
• l2vpn local-site-id remote-site-id command

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.