JUNOSe 9.1.x Quality of Service Configuration Guide > Monitoring QoS on E-series Routers > Monitoring the QoS Configuration of Fast Ethernet, Gigabit Ethernet, and 10-Gigabit Ethernet Interfaces

Monitoring the QoS Configuration of Fast Ethernet, Gigabit Ethernet, and 10-Gigabit Ethernet Interfaces

Purpose

Display information about the QoS configuration for a specific Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.

Action

To display the QoS configuration for a Fast Ethernet interface:

host1#show interfaces fastEthernet 6/0

GigEthernet6/0 is Up, Administrative status is Up

Hardware is Intel 21440, address is 0090.1a40.5508

MAU is 100BASE-TX

MTU: Operational 1522, Administrative 1522

Duplex Mode: Operational Full Duplex, Administrative Auto Negotiate

Speed: Operational 100 Mbps, Administrative Auto Negotiate

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

In: Bytes 0, Unicast 0

Multicast 0, Broadcast 0

Errors 0, Discards 0, Mac Errors 0, Alignment 0

CRC 0, Too Longs 0, Symbol Errors 0

Out: Bytes 64, Unicast 0

Multicast 0, Broadcast 1

Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 0

Collisions: Single 0, Multiple 0, Late 0, Excessive 0

Administrative qos-shaping-mode: cell

Operational qos-shaping-mode: cell

Attached QoS profile: ss

To display the QoS configuration for a Gigabit Ethernet interface:

host1#show interfaces gigabitEthernet 2/0

To display the QoS configuration for a 10-Gigabit Ethernet interface:

host1#show interfaces tenGigabitEthernet 5/0/0

Meaning

Table 51: show interfaces Output Fields 

Field Name	Field Description
Administrative qos-shaping-mode	QoS shaping mode: disabled frame cell none
Operational qos-shaping-mode	QoS shaping mode: disabled frame cell none
Attached QoS profile	QoS profile attachment at or below the displayed interface. For example, if the interface being displayed is a VLAN subinterface, and the attachment is at the Gigabit Ethernet interface, the Gigabit Ethernet attachment is displayed.

Table 51 lists the related show interfaces command output fields.

Related Topics

• Configuring the QoS Shaping Mode for Ethernet Interfaces
• Creating Parameter Instances
• For more information about other fields displayed with this command, see JUNOSe Physical Layer Configuration Guide, Chapter 5, Configuring Ethernet Interfaces
• show interfaces command