JUNOSe 9.1.x Multicast Routing Configuration Guide > Configuring IPv6 Multicast > Defining Static Routes for Reverse-Path Forwarding

Defining Static Routes for Reverse-Path Forwarding

Use the ipv6 rpf-route command to define reverse-path forwarding (RPF) to verify that a router receives a multicast packet on the correct incoming interface.

ipv6 rpf-route

• Use to customize static routes that the router may use for RPF.
• Specify the IPv6 address and subnet mask of the destination network.
• Specify either a next-hop IPv6 address or an interface type and specifier, such as atm 3/0. For details about interface types and specifiers, see JUNOSe Command Reference Guide, About This Guide.
• Optionally, specify the distance (number of hops) to the next-hop address.
• Example

host1(config)#ipv6 rpf-route 1000::/64 ATM2/1.200

• Use the no version to remove the static route.