Before You Configure PPP
Before you configure a PPP interface, configure the interface or tunnel over which PPP traffic will flow. See the following chapters:
- JUNOSe Physical Layer Configuration Guide, Chapter 1, Configuring Channelized T3 Interfaces
- JUNOSe Physical Layer Configuration Guide, Chapter 2, Configuring T3 and E3 Interfaces
- JUNOSe Physical Layer Configuration Guide, Chapter 3, Configuring Unchannelized OCx/STMx Interfaces
- JUNOSe Physical Layer Configuration Guide, Chapter 6, Managing Tunnel-Service and IPSec-Service Interfaces
- Chapter 1, Configuring ATM
- Chapter 9, Configuring Packet over SONET
- Chapter 10, Configuring Point-to-Point Protocol over Ethernet
The procedures described in this chapter assume that a physical interface has been configured.