JUNOSe 9.1.x Link Layer Configuration Guide > Configuring 802.3ad Link Aggregation and Link Redundancy > 802.3ad Link Aggregation Platform Considerations

802.3ad Link Aggregation Platform Considerations

You can configure 802.3ad link aggregation on the following E-series routers:

• E120 router
• E320 router
• ERX-1440 router
• ERX-1410 router
• ERX-710 router
• ERX-705 router
• ERX-310 router

Module Requirements

For information about the modules that support 802.3ad link aggregation on ERX-14xx models, ERX-7xx models, and the ERX-310 router:

• See ERX Module Guide, Table 1, Module Combinations for detailed module specifications.
• See ERX Module Guide, Appendix A, Module Protocol Support for information about the modules that support 802.3ad link aggregation.

For information about the modules that support 802.3ad link aggregation on the E120 router and the E320 router:

• See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module specifications.
• See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information about the modules that support 802.3ad link aggregation.

Interface Specifiers

The configuration task examples in this chapter use the format for ERX-7xx models, ERX-14xx models, and the ERX-310 router to specify 802.3ad link aggregation.

For example, the following command specifies a Gigabit Ethernet interface on port 0 of an I/O module in slot 4.

host1(config)#interface gigabitEthernet 4/0

When you configure a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface on E120 or E320 routers, you must include the adapter identifier as part of the interface specifier. For example, the following command specifies a Gigabit Ethernet interface on port 0 of the IOA installed in the upper adapter bay of slot 3.

host1(config)#interface gigabitEthernet 3/0/0

For more information about interface types and specifiers on E-series models, see Interface Types and Specifiers in JUNOSe Command Reference Guide, About This Guide.