JUNOSe 9.1.x BGP and MPLS Configuration Guide > Monitoring VPLS

Monitoring VPLS

This chapter describes the commands you can use to monitor and troubleshoot the virtual private LAN service (VPLS) on E-series routers.

This chapter contains the following sections:

• Setting a Baseline for VPLS Statistics
• Clearing All Dynamic MAC Addresses from the VPLS Forwarding Table
• Clearing BGP Attributes for VPLS
• Monitoring Bridging-Related Settings for VPLS
• Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance
• Monitoring VPLS Configuration and Statistics for all VPLS Instances
• Monitoring Configuration, Statistics, and Status for VPLS Network Interfaces
• Monitoring Configuration, Statistics, and Status for VPLS Core Interfaces
• Monitoring Configuration, Statistics, and Status for VPLS Ports
• Monitoring MAC Address Entries for a Specific VPLS Instance
• Monitoring Subscriber Policy Rules
• Monitoring BGP-Related Settings for VPLS
• Monitoring Layer 2 NLRI for VPLS Instances
• Monitoring BGP Next Hops for VPLS
• Monitoring LDP-Related Settings for VPLS
• Monitoring MPLS-Related Settings for VPLS
• Monitoring VPLS-Specific Settings
  

  NOTE: The E120 router and E320 router output for monitor and show commands is identical to output from other E-series routers, except that the E120 and E320 router output also includes information about the adapter identifier in the interface specifier (slot/adapter/port).