JUNOSe 9.1.x BGP and MPLS Configuration Guide > Layer 2 Services over MPLS Overview > Layer 2 Services over MPLS References

Layer 2 Services over MPLS References

For information about layer 2 services, consult the following resources:

• Encapsulation Methods for Transport of ATM Over MPLS Networks—draft-ietf-pwe3-atm-encap-07.txt (April 2005 expiration)
• Encapsulation Methods for Transport of Ethernet Frames Over IP/MPLS Networks—draft-ietf-pwe3-ethernet-encap-05.txt (June 2004 expiration)
• Encapsulation Methods for Transport of Layer 2 Frames Over IP and MPLS Networks—draft-martini-l2circuit-encap-mpls-08.txt (March 2005 expiration)
• Encapsulation Methods for Transport of PPP/HDLC Over IP and MPLS Networks—draft-ietf-pwe3-hdlc-ppp-encap-mpls-03.txt (October 2004 expiration)
• Framework for Pseudo Wire Emulation Edge-to-Edge (PWE3)—draft-ietf-pwe3-arch-06.txt (April 2004 expiration)
• IEEE 802.3ad (Link Aggregation)
• Pseudowire Setup and Maintenance Using LDP—draft-ietf-pwe3-control-protocol-08.txt (January 2005 expiration)
• Requirements for Pseudo-Wire Emulation Edge-to-Edge (PWE3)—draft-ietf-pwe3-requirements-08.txt (June 2004 expiration)
• Transport of Layer 2 Frames Over MPLS—draft-martini-12circuit-trans-mpls-11.txt (October 2003 expiration)
  

  NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must be considered as works in progress. Please refer to the IETF Web site at http://www.ietf.org for the latest drafts.

  
  

For information about configuring supported layer 2 interfaces, consult the following resources:

• JUNOSe Physical Layer Configuration Guide, Chapter 5, Configuring Ethernet Interfaces
• JUNOSe Link Layer Configuration Guide, Chapter 1, Configuring ATM
• JUNOSe Link Layer Configuration Guide, Chapter 2, Configuring Frame Relay
• JUNOSe Link Layer Configuration Guide, Chapter 9, Configuring Packet over SONET
• JUNOSe Link Layer Configuration Guide, Chapter 12, Configuring Bridged Ethernet

For information about configuring supported serial interfaces, which are also referred to as HDLC channels, see the following resources:

• JUNOSe Physical Layer Configuration Guide, Chapter 1, Configuring Channelized T3 Interfaces
• JUNOSe Physical Layer Configuration Guide, Chapter 2, Configuring T3 and E3 Interfaces
• JUNOSe Physical Layer Configuration Guide, Chapter 4, Configuring Channelized OCx/STMx Interfaces

For information about configuring MPLS, see Chapter 2, Configuring MPLS.