JUNOSe 9.1.x BGP and MPLS Configuration Guide > Monitoring Layer 2 Services over MPLS

Monitoring Layer 2 Services over MPLS

This chapter describes the commands you can use to monitor and troubleshoot layer 2 services over MPLS on E-series routers.

This chapter contains the following sections:

• Setting Baselines for Layer 2 Services over MPLS Statistics
• Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
• Monitoring ATM Subinterfaces for Layer 2 Services over MPLS
• Monitoring ATM Cross-Connects for Layer 2 Services over MPLS
• Monitoring MPLS Forwarding for Layer 2 Services over MPLS
• Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS

To monitor layer 2 services over MPLS, use the show commands described in this chapter.

NOTE: The E120 router and E320 router output for monitor and show commands is identical to output from other E-series routers, except that the E120 and E320 router output also includes information about the adapter identifier in the interface specifier (slot/adapter/port).