JUNOSe 9.1.x Command Reference Guide N to Z > T-U-V-W-X-Y-Z Commands > traps

traps

Description: 

Specifies OSPF trap settings. The no version removes all OSPF trap settings or any specified traps.

Syntax: 

[ no ] traps { all | [ virtIfStateChange | nbrStateChange | virtNbrStateChange |
ifConfigError | virtIfConfigError | ifAuthFailure | virtIfAuthFailure | ifRxBadPkt |
virtIfRxBadPkt | txRetransmit | virtTxRetransmit | originateLsa | maxAgeLsa |
ifStateChange ]* }

• all—Enables all OSPF traps
• virtIfStateChange—Sets a trap to indicate a state change on an OSPF virtual interface
• nbrStateChange—Sets a trap to indicate a state change on a nonvirtual OSPF neighbor
• virtNbrStateChange—Sets a trap to indicate a state change on a virtual OSPF neighbor
• ifConfigError—Sets a trap to indicate a configuration mismatch with a nonvirtual neighbor
• virtIfConfigError—Sets a trap to indicate a configuration mismatch with a virtual neighbor
• ifAuthFailure—Sets a trap to indicate an authentication failure on a nonvirtual interface
• virtIfAuthFailure—Sets a trap to indicate an authentication failure on a virtual interface
• ifRxBadPkt—Sets a trap to indicate that a packet has been received that cannot be parsed
• virtIfRxBadPkt—Sets a trap to indicate that a packet has been received on a virtual interface that cannot be parsed
• txRetransmit—Sets a trap to indicate that a packet has been retransmitted on a nonvirtual interface
• virtTxRetransmit—Sets a trap to indicate that a packet has been retransmitted on a virtual interface
• originateLsa—Sets a trap to indicate that a new LSA has been originated by this router
• maxAgeLsa—Sets a trap to indicate that an LSA in this router LSDB has reached MaxAge
• ifStateChange—Sets a trap to indicate a state change on an OSPF interface
• *—Indicates that one or more parameters can be repeated multiple times in a list in the command line

Mode(s): 

Router Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.