JUNOSe 9.1.x Command Reference Guide N to Z > T-U-V-W-X-Y-Z Commands > timers

timers

Description: 

Configures RIP timers. The no version restores the default values.

Syntax: 

timers update invalid holddown flush

no timers

• update—Interval in seconds at which routing updates are sent; default value is 30
• invalid—Interval in seconds after which a route is declared invalid (null); default value is 180
• holddown—Interval in seconds during which routing information regarding better paths is disregarded by the router; default value is 120
• flush—Interval in seconds that must pass before a route is removed from the routing table; set this value greater than the invalid value; default value is 300

Mode(s): 

Address Family Configuration, Router Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.