JUNOSe 9.1.x Command Reference Guide N to Z > T-U-V-W-X-Y-Z Commands > threshold

threshold

Description: 

Sets the threshold values for bit error rates used in APS/MSP alarms. This command applies only to the protect interface, and not to the working interface. The no version restores the default value, 5 (for the sd-ber bit error rate) or 3 (for the sf-ber bit error rate), for the specified alarm.

Syntax: 

threshold { sd-ber | sf-ber } rate

no threshold { sd-ber | sf-ber }

• sd-ber—Bit error rate that specifies signal degradation
• sf-ber—Bit error rate that specifies signal failure
• rate—Integer n with available values depending on the bit error rate type you specify; a value of n corresponds to a rate of 10^-n (10e-n) errors per second

• For sd-ber, an integer in the range 5–9; default value is 5
• For sf-ber, an integer in the range 3–5; default value is 3

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.