JUNOSe 9.1.x Command Reference Guide N to Z > T-U-V-W-X-Y-Z Commands > table-map

table-map

Description: 

Applies the specified route map to all BGP, IS-IS, OSPF, or RIP routes about to be added to the IP routing table. The no version halts application of the route map.

Syntax: 

table-map mapTag

For removing route maps for IS-IS IPv6 only:

no table-map

For removing route maps for all other cases:

no table-map [ mapTag ]

• mapTag—A string of up to 32 alphanumeric characters that specifies the name of the route map; for each protocol, the route map can set only the following values:

• BGP—Distance, IP next hop, level, metric, metric type, route type, and tag values
• IS-IS—Distance, level, metric, metric type, origin, preference, route type, and tag values; IS-IS IPv6 supports only a single route map
• OSPF—Distance, metric, metric type, route type, and tag values
• RIP—Distance, metric, and tag values

Mode(s): 

Address Family Configuration (BGP, IS-IS, RIP), Router Configuration (BGP, IS-IS, OSPF, RIP)

Release Information: 

Command introduced before JUNOSe Release 7.1.0.