JUNOSe 9.1.x Command Reference Guide N to Z > S Commands > summary-address

summary-address

Description: 

Creates aggregate addresses for IS-IS or aggregates external routes at the border of the OSPF domain. The no version restores the default.

Syntax: 

IS-IS:

summary-address address mask [ level-1 | level-1-2 | level-2 ] [ metric ] [ tag tagValue ]

no summary-address address mask [ level-1 | level-1-2 | level-2 ]

• address—Summary IP address designated for a range of addresses
• mask—IP subnet mask used for the summary route
• level-1—Summarizes routes redistributed into level 1; when distributing routes domain wide, summarizes routes leaked from level 2 into level 1
• level-1-2—Summarizes routes redistributed into level 1 and level 2 IS-IS, and routes leaked between levels
• level-2—Summarizes routes learned by level 1 routing into the level 2 backbone with the configured address/mask value; also summarizes routes redistributed into level 2 IS-IS
• metric—Number in the range 1–16777215; the default metric value. The summary uses this value when advertising the summary address. When no metric is supplied, uses the value of the lowest-cost route that this is summarizing (default).
• tagValue—Number in the range 1–4294967295 that identifies the route tag assigned to the IS-IS summary address

OSPF:

[ no ] summary-address address mask

• address—Summary address designated for a range of addresses
• mask—IP subnet mask used for the summary route

Mode(s): 

Router Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.