show l2tp tunnel
Displays detailed information about the configured and operational status of selected L2TP tunnels or summary information for all L2TP tunnels.
show l2tp tunnel [ detail ] [ state { adminState | ifOperStatus |
failover-resync failoverResyncMode } ]
[ l2tpName | [ virtual-router vrName ] ip ipAddress [ l2tpNameNoDest ] ] [ filter ]To display summary information:
show l2tp tunnel summary [ filter ]
- detail—Provides complete information about the specified sessions, including the L2TP host profile name
- adminState—Displays information about tunnels only with the specified effective administrative state
- enabled—Effective administrative state is disabled
- disabled—Effective administrative state is enabled
- drain—Effective administrative state is drain
- up—Operational state is up
- down—Operational state is down
- lower-down— Operational state is lower down
- not-present—Operational state is not-present
- failoverResyncMode—Displays information about tunnels that use the specified failover resynchronization mode:
- disable—Peer failover resynchronization is disabled
- failover-protocol—Uses the L2TP failover protocol method
- failover-protocol-fallback-to-silent-failover—Uses the L2TP failover protocol method; however, if the peer does not support this method, the silent failover method is used
- not-configured—Uses the global failover method because peer failover resynchronization is not configured for L2TP host profiles and AAA domain map tunnels
- silent-failover—Uses the L2TP silent failover method
- l2tpName—Tunnel name
- vrName—Name of the virtual router on which the tunnel exists
- ipAddress—IP address
- l2tpNameNoDest—Tunnel name
- filter—See Filtering show Commands in About This Guide
- summary—Displays the configured and operational status of all L2TP tunnels
Privileged Exec
Command introduced before JUNOSe Release 7.1.0.
failover-resync keyword and failoverResyncMode variable added in JUNOSe Release 9.0.0.