show bgp ipv6 network
Displays information about a potentially originated prefix that was configured with the network command.
To display information about a prefix configured for all address families or for a specific address family other than the route-target address family:
show bgp ipv6 [ unicast | multicast | vpnv6 all | vpnv6 vrf vrfName ]
network [ ipv6Prefix ] [ filter ]To display information about about a prefix configured for the route-target address family:
show bgp ipv6 route-target signaling network [ rtfPrefix ] [ filter ]
- unicast—Specifies the IPv6 unicast address family and routing table; the default option
- multicast—Specifies the IPv6 multicast address family and routing table
- vpnv6 all—Specifies the VPN-IPv6 address family and all IPv6 VPN routing and forwarding instances
- vpn6 vrf vrfName—Specifies the VPN-IPv6 address family and only the IPv6 VPN routing and forwarding instance with the name vrfName
- ipv6Prefix—Prefix that defines the IPv6 network that you want to filter
- route-target signaling—Displays information for only the route-target address family
- rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in the format asNumber:extendedCommunity/prefixLength (for example, 320:320:524/36) where:
- asNumber—AS number for origin of route target information, in the range 1–4294967295
- extendedCommunity—Two-part number in the format number1:number2 that identifies an extended community of VPNs, in the format number1:number2, where:
- number1—Autonomous system (AS) number, in the range 1–4294967295, or an IP address
- number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit AS number; 16 bits if number1 is an IP address or a 32-bit AS number
- filter—See Filtering show Commands in About This Guide
Privileged Exec, User Exec
Command introduced before JUNOSe Release 7.1.0.
route-target signaling keywords and rtMemNlri variable added in JUNOSe Release 9.0.0.
rtMemNlri variable replaced by rtfPrefix variable in JUNOSe Release 9.1.0.