JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > rename

rename

Description: 

Renames a local file. There is no no version.

NOTE: You cannot change the extension of a file, for example, from .mac to .scr. See Renaming Files in JUNOSe System Basics Configuration Guide, Chapter 5, Managing the System, for detailed information on file type usage with the rename command.

Syntax: 

rename [ sourcePath]sourceFilename [ destinationPath]destinationFilename

• sourcePath—Path to the source in the format:
  hostName: | deviceName: | /incoming/subdirectory/ | /outgoing/subdirectory/

• hostName:—Name of the network host
• deviceName:—Name of the device specifying a flash card slot

• disk0—Specifies flash card slot 0 on the primary SRP module; if no device is specified for the primary SRP module, then disk0 is used
• disk1—Specifies flash card slot 1 on the primary SRP module; source and destination file types must be .dmp; supported only on the E120 router and the E320 router
• standby—Specifies flash card slot 0 on the standby SRP module for backward compatibility
• standby-disk0—Specifies flash card slot 0 on the standby SRP module
• standby-disk1—Specifies flash card slot 1 on the standby SRP module; source and destination file types must be .dmp; supported only on E120 and E320 routers

• incoming—Specifies the router's incoming FTP directory
• subdirectory—Name of a subdirectory on the router's FTP server. If the subdirectory does not exist, the router creates it.
• outgoing—Specifies the router's outgoing FTP directory

• sourceFileName—File to rename
• destinationPath—Path to the destination in the format:
  networkPath | /incoming/subdirectory | /outgoing/subdirectory

• networkPath—Path to the network host
• incoming—Specifies the incoming router's FTP directory
• subdirectory—Name of a subdirectory on the router's FTP server. If the subdirectory does not exist, the router creates it.
• outgoing—Specifies the router's outgoing FTP directory

• destinationFileName—New filename

Mode(s): 

Privileged Exec

Release Information: 

Command introduced before JUNOSe Release 7.1.0.
hostName and deviceName variables added in JUNOSe Release 7.2.0.