JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > remote-neighbor

remote-neighbor

Description: 

Configures an OSPF, PIM, or RIP remote neighbor. The no version removes the remote neighbor and any attributes configured for the neighbor.

NOTE: For PIM, this command is typically used when you configure PIM remote neighbors to run multicast services over BGP/MPLS VPNs. That functionality is no longer supported.

Syntax: 

For OSPF:

[ no ] remote-neighbor ipAddress area { areaId | areaIdInt }

For PIM:

[ no ] remote-neighbor [ ipAddress | ipv6Address ] sparse-mode

For RIP:

[ no ] remote-neighbor ipAddress

• ipAddress—IPv4 address identifying the remote neighbor
• areaId—OSPF area ID in IP address format
• areaIdInt—OSPF area ID as a decimal value, in the range 0–4294967295
• ipv6Address—IPv6 address identifying the remote neighbor

Mode(s): 

Router Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.