JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > redundant-port

redundant-port

Description: 

Specifies a member link of a LAG bundle as redundant. The no version disables the redundant status of the member link or disables the specified redundancy setting for the member link.

Syntax: 

To specify a member interface with optional failover timeout and packet sampling settings:

[ no ] redundant-port interfaceType interfaceSpecifier [ [ failover timeout failoverTime ]
[ packet-sampling [ delay delayTime ] ] ]

To specify a member interface with optional auto-reversion, transmitter, and failover timeout settings:

[ no ] redundant-port interfaceType interfaceSpecifier [ [ auto-revert ] [ transmitter { on | off } ] [ failover timeout failoverTime ] ]

• interfaceType—Interface type; see Interface Types and Specifiers in About This Guide
• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide
• failoverTime—Time between the current link event leading to failover or reversion and the previous link failover or reversion, in the range 100-10000 milliseconds (ms)
• packet-sampling—Enables packet sampling to determine a failed port
• delayTime—Minimum time difference between redundant and active port samples, in the range 100–10000 milliseconds (ms)
• auto-revert—Specifies that the failed port automatically resumes as active
• on—Specifies the transmitter is enabled when port is in redundant mode
• off—Specifies the transmitter is disabled when port is in redundant mode

Mode(s): 

Global Configuration

Release Information: 

Command introduced in JUNOSe Release 8.0.0.