JUNOSe 9.1.x Command Reference Guide N to Z > N Commands > nsf t2

nsf t2

Description: 

Specifies the maximum amount of time, in seconds, that an IS-IS restarting router waits for the LSP database to synchronize. You must configure separate instances of the T2 timer for each IS-IS level at which the router operates. The no version restores the default T2 wait time, 30 seconds.

Syntax: 

[ no ] nsf t2 { level-1 | level-2 } [ seconds ]

• level-1—Sets the T2 wait time independently for level 1 routing
• level-2—Sets the T2 wait time independently for level 2 routing
• seconds—Maximum wait time, in the range 5–120 seconds, for LSP database synchronization; default value is 30 seconds

Mode(s): 

Router Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.