JUNOSe 9.1.x Command Reference Guide A to M > M Commands > mpls l2transport load-balancing-group

mpls l2transport load-balancing-group

Description: 

Specifies a Martini layer 2 transport circuit, associates it with a load-balancing group, and accesses L2 Transport Load-Balancing-Circuit Configuration mode. The no version removes a circuit from the load-balancing group and all subinterfaces that the circuit was configured on.

Syntax: 

mpls l2transport load-balancing-group groupNumber
[ mpls-relay remoteIpAddress | route interface tunnel lspName ]
[ vc-id ] vcId [ group-id groupId ]
[ control-word | no-control-word ] [ sequencing | no-sequencing ]
[ relay-format { ethernet | ppp | vlan } ]

no mpls l2transport load-balancing-group groupNumber
{ mpls-relay remoteIpAddress | route interface tunnel lspName } [ vc-id ] vcId

• groupNumber—Integer in the range 1–127

 NOTE: For definitions of all other options, see the mpls-relay command or the route interface command. Using the mpls-relay keywords has the same effect as using the mpls-relay command. Using the route interface keywords has the same effect as using the route interface commands. The relay-format frame-relay option is not supported for the mpls l2transport load-balancing-group command. 



 

Mode(s): 

Global Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.
control-word, no-control-word, sequencing, and no-sequencing keywords added in JUNOSe Release 7.1.0.

    Related Topics    

• Configuring CE-Side Load Balancing for Martini Layer 2 Transport