JUNOSe 9.1.x Command Reference Guide A to M > M Commands > mpls topology-driven-lsp ip-interfaces

mpls topology-driven-lsp ip-interfaces

Description: 

Specifies LSPs to be put into the IP routing table for forwarding plain IP traffic. The no version removes the LSPs from the table.

NOTE: This command is deprecated and may be removed completely in a future release. The function provided by this command has been replaced by the ldp ip-forwarding command.

Syntax: 

[ no ] mpls topology-driven-lsp ip-interfaces [ egress | ingress ]
[ { access-list | prefix-list } listName ] [ host-only ]

no mpls topology-driven-lsp ip-interfaces [ egress | ingress ] [ host-only ] [ policy-list ]

• egress—Has no effect
• ingress—Has no effect
• access-list—Specifies that listName is an access list
• prefix-list—Specifies that listName is a prefix list
• listName—Name of access list or prefix list that specifies LSPs over which IP interfaces are created
• host-only— Specifies that only LSPs to host addresses are added to the IP routing table
• policy-list—Removes previously applied access lists or prefix lists

Mode(s): 

Global Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.