JUNOSe 9.1.x Command Reference Guide A to M > M Commands > mpls ldp vpls neighbor

mpls ldp vpls neighbor

Description: 

Configures the remote VPLS edge (VE) device address of a neighbor in the VPLS domain in which the VPLS instance participates. The specified VPLS instance must use LDP as the signaling protocol. If either or both LDP or MPLS are not configured on the current virtual router, issuing this command creates the LDP and MPLS configurations automatically. The no version deletes the neighbor from the VPLS domain.

The mpls ldp vpls neighbor command is not valid for a VPLS instance that uses BGP as the signaling protocol. To configure a VPLS instance with BGP signaling, use the bridge vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls site-range commands.

Syntax: 

[ no ] mpls ldp vpls vplsName neighbor ipAddress

• vplsName—Name of a VPLS instance created with the bridge vpls transport-virtual-router command
• ipAddress—IP address of a neighbor in the VPLS domain

Mode(s): 

Global Configuration

    Release Information    Command introduced in JUNOSe Release 8.2.0.

    Related Topics    

• Configuring LDP Signaling for VPLS