JUNOSe 9.1.x Command Reference Guide A to M > J-K-L Commands > log-adjacency-changes

log-adjacency-changes

Description: 

Generates a log message when the state of an IS-IS adjacency or an OSPFv3 neighbor changes. For OSPFv2 neighbors, use the ospf log-adjacency-changes command. Manipulates the same log as the Global Configuration log commands. The no version disables this function.

Syntax: 

For IS-IS adjacencies:

log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]

no log-adjacency-changes

For OSPFv3 adjacencies:

[ no ] log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]

• severity—Sets minimum severity of the log messages for this category; described either by a descriptive term—severityValue—or by a corresponding number—severityNumber—in the range 0–7. The lower the number, the higher the priority:

• emergency or 0—System unusable
• alert or 1—Immediate action needed
• critical or 2—Critical condition exists
• error or 3—Error condition
• warning or 4—Warning condition
• notice or 5—Normal but significant condition
• info or 6—Informational message
• debug or 7—Debug message

• verbosity—Specifies the verbosity of this log category's messages
• verbosityLevel—Specifies the verbosity of the log category's messages; can be any of the following:

• high—Verbose
• low—Terse
• medium—Moderate detail

Mode(s): 

Router Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.