JUNOSe 9.1.x Command Reference Guide A to M > I Commands > ip address

ip address

Description: 

Sets a primary or secondary IP address for an interface or subinterface. The no version removes an IP address or disables IP processing. You must specify the layer 2 encapsulation before you can set the IP address.

Syntax: 

ip address ipAddress ipMask [ secondary ]

no ip address [ ipAddress ipMask [ secondary ] ]

• ipAddress—IP address in 32-bit dotted decimal format (for example, 192.56.32.2)
• ipMask—mask for associated IP subnet in dotted decimal or prefix length notation
• secondary—Specifies that the configured address is a secondary IP address; if omitted, the configured address is the primary IP address

Mode(s): 

Interface Configuration, Profile Configuration, Subinterface Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.

    Related Topics    

• Configuring Local ATM Cross-Connects with AAL5 Encapsulation
• Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces
• Configuring the Loopback Interface and Router ID for BGP for L2VPNs
• Configuring the Loopback Interface and Router ID for VPLS
• Configuring MPLS LSPs for L2VPNs