JUNOSe 9.1.x Command Reference Guide A to M > I Commands > ipv6 nd reachable-time

ipv6 nd reachable-time

Description: 

Specifies the amount of time that the E-series router can reach a remote IPv6 node after some reachability confirmation event has occurred. The no version restores the default value 0 milliseconds for router advertisements and 3,600,000 milliseconds (1 hour) for Neighbor Discovery activity of the E-series router.

Syntax: 

ipv6 nd reachable-time { milliseconds | hours minutes seconds }

no ipv6 nd reachable-time

• milliseconds—Amount of time, in the range 0–21600000 milliseconds, that the E-series router can reach a remote node after some reachability confirmation event has occurred
• hours minutes seconds—Amount of time, in the range 0 hours 0 minutes
  0 seconds – 6 hours 0 minutes 0 seconds, that the E-series router can reach a remote node after some reachability confirmation event has occurred; this specification is not supported in Profile Configuration mode

Mode(s): 

Interface Configuration, Profile Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.
Profile Configuration mode added in JUNOSe Release 9.0.0.