JUNOSe 9.1.x Command Reference Guide A to M > I Commands > ip vrrp accept-data

ip vrrp accept-data

Description: 

Enables the backup router to process packets with an IP destination address equivalent to the virtual addresses while the backup router is in the master state. The no version restores the default value, disabled.

NOTE: When using this attribute and also restricting incoming packets to ICMP only, you must use policy filters to accept only ICMP packets with the virtual address as the destination address.

Syntax: 

[ no ] ip vrrp vrid accept-data

• vrid—VRID identifier; a number in the range 1–255

Mode(s): 

Interface Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.