JUNOSe 9.1.x Command Reference Guide A to M > I Commands > interface atm

interface atm

Description: 

Configures an ATM interface or subinterface type. The no version removes the interface or subinterface.

NOTE: On the OC3-2 GE APS I/O module, you can configure only OC3/STM1 ATM interfaces in ports 0 and 1. Port 2 is reserved for a Gigabit Ethernet interface.

Syntax: 

[ no ] interface atm interfaceSpecifier [ multipoint | point-to-point ]

• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide
• multipoint—Specifies an NBMA subinterface
• point-to-point—Specifies an ATM interface or subinterface; default

Mode(s): 

Global Configuration, Interface Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.

    Related Topics    

• Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation
• Configuring Local ATM Cross-Connects with AAL5 Encapsulation
• Configuring MPLS LSPs for L2VPNs