JUNOSe 9.1.x Command Reference Guide A to M > A Commands > address transmit-delay

address transmit-delay

Description: 

Sets the estimated time it takes to transmit a link-state update packet on the interface. The no version restores the default value.

NOTE: You must issue the address area command before issuing this command.

Syntax: 

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
transmit-delay transmDelay

• ipAddress—OSPF interface address previously specified with the address command
• unnumbered—Indicates that OSPF is running on an unnumbered interface previously specified with the address command

• interfaceType—Interface type; see Interface Types and Specifiers in About This Guide
• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide

• transmDelay—Link-state transmit delay, a number in the range 0–3600 seconds; default value is 1 second

Mode(s): 

Router Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.