Creating Rate-Limit Profiles
This chapter provides information for configuring rate-limit policy management on E-series routers.
This chapter discusses the following topics:
- Rate Limits for Interfaces Overview
- Hierarchical Rate Limits Overview
- Percent-Based Rates for Rate-Limit Profiles Overview
- Policy Parameter Quick Configuration
- Creating Rate-Limit Profiles
- One-Rate Rate-Limit Profiles Overview
- Creating a One-Rate Rate-Limit Profile
- Configuring a TCP-Friendly One-Rate Rate-Limit Profile
- Two-Rate Rate-Limits Overview
- Creating a Two-Rate Rate-Limit Profile
- Setting the Committed Action for a Rate-Limit Profile
- Setting the Committed Burst for a Rate-Limit Profile
- Setting the Committed Rate for a Rate-Limit Profile
- Setting the Conformed Action for a Rate-Limit Profile
- Setting the Exceeded Action for a Rate-Limit Profile
- Setting the Excess Burst for a Rate-Limit Profile
- Setting the Mask Value for MPLS Rate-Limit Profiles
- Setting the Mask Value for IP and IPv6 Rate-Limit Profiles
- Setting the Peak Burst for Two-Rate Rate-Limit Profiles
- Setting the Peak Rate for Rate-Limit Profiles
- Setting a One-Rate Rate-Limit Profile
- Setting a Two-Rate Rate-Limit-Profile
- Bandwidth Management Overview
- Rate-Limiting Traffic Flows
For information on monitoring rate-limit profiles, see Chapter 9, Monitoring Policy Management.