JUNOSe 9.1.x Multicast Routing Configuration Guide > Configuring IPv6 Multicast > Defining Permanent IPv6 Multicast Forwarding Entries

Defining Permanent IPv6 Multicast Forwarding Entries

An mroute is a multicast traffic flow (a (Source, Group) entry used for forwarding multicast traffic). By default, forwarding mroutes (with a valid RPF incoming interface) are timed out if data for them is not received for 210 seconds. However, you can specify an mroute as permanent by using the ipv6 multicast-routing permanent-mroute command.

ipv6 multicast-routing permanent-mroute

• Use to specify that any newly created mroutes that match the specified access-list do not time out.
• Using this command does not change existing mroutes.
• Permanent mroutes are removed if a topology change occurs that affects the mroute.
• Permanent mroutes may be removed due to certain protocol actions (for example, PIM sparse mode switching from shared to shortest path tree).
• Outgoing interface lists of permanent mroutes may change due to protocol actions.
• Example

host1(config)#ipv6 multicast-routing permanent-mroute routesv61

• Use the no version to prevent any new mroutes from becoming permanent. To remove existing permanent mroutes, use the clear ipv6 mroute command.