JUNOSe 9.1.x Link Layer Configuration Guide > Configuring Upper-Layer Protocols over Static Ethernet Interfaces > Upper-Layer Protocols over Static Ethernet Platform Considerations

Upper-Layer Protocols over Static Ethernet Platform Considerations

You can configure upper-layer protocols over Ethernet on the following E-series routers:

• E120 router
• E320 router
• ERX-1440 router
• ERX-1410 router
• ERX-710 router
• ERX-705 router
• ERX-310 router

Module Requirements

For information about the modules supported on E-series routers:

• See the ERX Module Guide for modules supported on ERX-7xx models, ERX-14xx models, and the ERX-310 router.
• See the E120 and E320 Module Guide for modules supported on the E120 router and the E320 router.

Interface Specifiers

The configuration task examples in this chapter use the format for ERX-7xx models, ERX-14xx models, and the ERX-310 router to specify a VLAN or S-VLAN subinterface.

For ERX-7xx models, ERX-14xx models, and ERX-310 routers, use the slot/port[.subinterface ] format. For example, the following command specifies a VLAN subinterface configured on port 0 of an I/O module in slot 4.

host1(config)#interface fastEthernet 4/0.1

For E120 and E320 routers, use the slot/adapter/port[.subinterface ] format, which includes an identifier for the bay in which the I/O adapter (IOA) resides. For example, the following command specifies a VLAN subinterface configured on port 0 of the IOA installed in the upper adapter bay of slot 3.

host1(config)#interface gigabitEthernet 3/0/0.1

For more information about interface types and specifiers on E-series models, see Interface Types and Specifiers in JUNOSe Command Reference Guide, About This Guide.