JUNOSe 9.1.x Link Layer Configuration Guide > Configuring ATM > Configuring an NBMA Interface

Configuring an NBMA Interface

You configure an ATM NBMA 1483 subinterface in a manner similar to configuring a standard ATM 1483 subinterface. When you specify a subinterface, however, you must select the multipoint option if you plan to add multiple circuits to form an NBMA interface. If you do not select multipoint, the subinterface defaults to point-to-point, and only a single circuit can be affiliated with that subinterface.

You can configure one or more PVCs and associate them with the subinterface you create. Also, you can enable InARP and identify a refresh rate on each specific circuit. For each NMBA interface, either InARP must be enabled, or a static map entry must be provided for each circuit owned by the interface; otherwise, transmitting over that circuit is impossible.

NOTE: NBMA interfaces support only the aal5snap encapsulation.

To configure an NBMA interface:

1. Configure a physical interface.

host1(config)#interface atm 2/0 

2. Configure an ATM 1483 subinterface.

host1(config-if)#interface atm 2/0.2 multipoint

3. Configure PVCs by specifying the VCD, VPI, VCI, and encapsulation type.

host1(config-subif)#atm pvc 1 1 1 aal5snap inarp 10

host1(config-subif)#atm pvc 2 2 2 aal5snap

4. (Optional) Specify InARP and a refresh rate (also optional).

host1(config-subif)#atm pvc 3 3 3 aal5snap inarp 5

host1(config-subif)#atm pvc 4 4 4 aal5snap inarp

5. Assign an IP address and subnet mask to the PVC.

host1(config-subif)#ip address 192.32.10.20 255.255.255.0

6. (Optional) Use the appropriate show commands to verify your configuration.

host1#show atm interface atm 2/0

host1#show atm map

host1#show nbma arp atm 2/0

host1#show atm vc atm 2/0 2

host1#show atm subinterface atm 2/0.2