JUNOSe 9.1.x Command Reference Guide N to Z > T-U-V-W-X-Y-Z Commands > update-source

update-source

Description: 

Specifies the loopback interface whose local address is used as the source address for the OSPF, PIM, or RIP connection to a remote neighbor. The no version deletes the source address from the connection.

NOTE: For PIM, this command is typically used when you configure PIM remote neighbors to run multicast services over BGP/MPLS VPNs. That functionality is no longer supported.

Syntax: 

For OSPF:

[ no ] update-source loopback interfaceSpecifier

• interfaceSpecifier—Integer, in the range 1–4294967293, identifying the loopback interface

For PIM:

update-source interfaceType interfaceSpecifier

no update-source [ interfaceType interfaceSpecifier ]

For RIP:

[ no ] update-source interfaceType interfaceSpecifier

• interfaceType—Interface type; see Interface Types and Specifiers in About This Guide
• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide

Mode(s): 

Remote Neighbor Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.