JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds3 t1 clock source

path ds3 t1 clock source

Description: 

Configures the transmit clock source for a T1 channel on a DS3 signal. This command applies to a T1 channel on a DS3 over channelized SONET interface. The no version restores the default value, line.

Syntax: 

path pathChannel ds3 ds3Channel t1 t1Channel clock source
{ line | internal { module | chassis } }

no path pathChannel ds3 ds3Channel t1 t1Channel clock source

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
• t1Channel—One or more individual T1 channels, ranges of T1 channels, or combination of individual channels and ranges, in the range 1–28 (no spaces); for example, 3,7-15,19-13,27
• line—Interface transmits data from a clock recovered from the line's receive data stream
• internal—Interface transmits data using its internal clock. You must specify one of the following for internal clocking:

• module—Internal clock is from the line module itself
• chassis—Internal clock is from the configured system clock

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.