JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds3 mdl transmit

path ds3 mdl transmit

Description: 

Enables you to transmit an MDL message on a DS3 signal. This command applies to a DS3 over channelized SONET interface. The no version disables transmission of the specified message or all messages.

Syntax: 

[ no ] path pathChannel ds3 ds3Channel mdl transmit
{ path-id | idle-signal | test-signal }

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• ds3Channel—Number, in the range 1–3, that identifies the path
• path-id—Transmits a path identification message every second; default value is disabled
• idle-signal—Transmits an idle signal message every second; default value is disabled
• test-signal—Transmits a test signal message every second; default value is disabled

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.