JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds1 fdl transmit

path ds1 fdl transmit

Description: 

Configures the router to send the specified FDL message on a DS1 signal. This command applies to a DS1 over channelized SONET or SDH interface. The no version stops the router from sending the specified FDL message or all FDL messages.

Syntax: 

[ no ] path pathChannel ds1 tributaryIdentifier fdl transmit
{ path-id | idle-signal | test-signal }

no path pathChannel ds1 tributaryIdentifier fdl transmit

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• tributaryIdentifier—Identifier for the tributary. See description for the path ds1|e1 command.
• path-id—Transmits a path identification message every second; default value is disabled
• idle-signal—Transmits an idle signal message every second; default value is disabled
• test-signal—Transmits a test signal message every second; default value is disabled

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.