JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds1 fdl string

path ds1 fdl string

Description: 

Defines an FDL message for a DS1 signal, as defined in the ANSI T1.403 specification. This command applies to a DS1 over channelized SONET or SDH interface. Currently, FDL strings can only be configured locally. The no version restores the default value to the specified FDL message or to all FDL messages.

Syntax: 

path pathChannel ds1 tributaryIdentifier fdl string { eic eicValue | fic ficValue |
lic licValue | unit unitValue | pfi pfiValue | port portValue | generator generatorValue }

no path pathChannel ds1 tributaryIdentifier fdl string { eic | fic | lic | unit | pfi | port |
generator }

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• tributaryIdentifier—Identifier for the tributary. See description for the path ds1|e1 command.
• eicValue—Equipment identification code; 1–10 characters; default value is the null value
• ficValue—Frame identification code; 1–10 characters; default value is the null value
• licValue—Line identification code; 1–10 characters; default value is the null value
• unitValue—Unit identification code; 1–6 characters; default value is the null value.
• pfiValue—Facility identification code to send in the FDL path message; 1–38 characters; default value is the null value
• portValue—Equipment port number to send in the FDL idle signal message; 1–38 characters; default value is the null value
• generatorValue—Generator number to send in the FDL test signal message; 1–38 characters; default value is the null value

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.