JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds1 fdl carrier

path ds1 fdl carrier

Description: 

Specifies that a DS1 signal is used in the carrier environment. This command applies to a DS1 over channelized SONET or SDH interface. The no version restores the default situation, in which an interface does not operate in the carrier environment.

Syntax: 

[ no ] path pathChannel ds1 tributaryIdentifier fdl carrier

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• tributaryIdentifier—Identifier for the tributary. See description for the path ds1|e1 command.

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.