JUNOSe 9.1.x Command Reference Guide N to Z > O-P-Q-R Commands > path ds1|e1 channel-group timeslots

path ds1|e1 channel-group timeslots

Description: 

Configures DS1 or E1 line parameters on channelized SONET and SDH interfaces. To configure a line, you specify a DS1 or an E1 channel group number and assign a range of timeslots. To configure a whole DS1 or E1 line, assign all the timeslots to the channel group. You can specify a line speed that applies to all DS0 timeslots assigned to a channel group. The no version removes the timeslots from the channel group.

Syntax: 

path pathChannel { ds1 | e1 } tributaryIdentifier
channel-group channelGroupNumber timeslots range [ speed { 56 | 64 } ]

no pathChannel { ds1 | e1 } tributaryIdentifier channel-group channelGroupNumber

• pathChannel—Number, in the range 1–2147483648, that identifies the path
• tributaryIdentifier—Identifier for the tributary. See description for the path ds1|e1 command.
• channelGroupNumber—Either a fractional T1 interface in the range 1–24 or a fractional E1 interface in the range 1–31
• range—Timeslot assigned to the T1 or E1 channel in the range 1–31. A dash represents a range of timeslots, and a comma separates timeslots. For example, 1-10, 15-18 assigns timeslots 1–10 and 15 –18.
• speed—Specifies the data rate for the T1 or E1 channel, either 56 Kbps or 64 Kbps; default value is 64 Kbps

Mode(s): 

Controller Configuration

Release Information: 

Command introduced before JUNOSe Release 7.1.0.