JUNOSe 9.1.x Command Reference Guide A to M > E-F-G-H Commands > flash-disk initialize

flash-disk initialize

Description: 

Performs a low-level format of unmounted flash cards. There is no no version.

Syntax: 

flash-disk initialize [ no-format ] [ disk0 | disk1 ]

• no-format—Erases all files but does not format the flash card
• disk0—Specifies flash card in slot 0 of the SRP module; default value is disk0; available only in Boot mode, because disk0 cannot be in an unmounted state in a router outside of Boot mode
• disk1—Specifies flash card in slot 1 of the SRP module; supported only on the E120 router and the E320 router

Mode(s): 

Boot, Privileged Exec

    Release Information    Command introduced before JUNOSe Release 7.1.0.
disk0 and disk1 keywords added in JUNOSe Release 7.2.0.
Privileged Exec mode added in JUNOSe Release 8.0.0.