JUNOSe 9.1.x Command Reference Guide A to M > A Commands > address hello-interval

address hello-interval

Description: 

Specifies the interval between hello packets that the router sends on the interface. The no version resets the hello interval to its default.

NOTE: You must issue the address area command before issuing this command.

Syntax: 

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
hello-interval helloInterval

• ipAddress—OSPF interface address previously specified with the address command
• unnumbered—Indicates that OSPF is running on an unnumbered interface previously specified with the address command

• interfaceType—Interface type; see Interface Types and Specifiers in About This Guide
• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide

• helloInterval—Number in the range 1–65535 seconds; default value is 10 seconds

Mode(s): 

Router Configuration

    Release Information    Command introduced before JUNOSe Release 7.1.0.