JUNOSe 9.1.x Command Reference Guide A to M > A Commands > adapter enable

adapter enable

Description: 

Enables the IOA installed in the specified IOA bay. There is no no version.

NOTE: For IOAs that support hot-swapping, issuing this command does not reboot the line module. For IOAs that do not support hot-swapping, issuing this command reboots the line module associated with the IOA, but it does not enable it. To enable the line module and its associated IOAs, issue the slot enable command.

Syntax: 

adapter enable adapterSpecifier

• adapterSpecifier—Particular IOA in the format slot/adapter:

• slot—Number of the chassis slot; for E120 routers, in the range 0–5; for E320 routers, in the range 0–5 or 11–16
• adapter—Identifier for the IOA within the chassis slot, either 0 or 1, where:

• 0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper IOA bay (E320 router).
• 1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower IOA bay (E320 router).

Mode(s): 

Global Configuration

    Release Information    Command introduced in JUNOSe Release 7.1.0.