Required Tools, Wires, and Cables

Cabling your system takes only a few minutes. You need the following items and those listed in Table 7 for proper installation:

• 1/8–inch flathead screwdriver
• 3/8–inch wrench or 3/8–inch nut-driver
• No. 2 Phillips screwdriver
• Ground wires—We recommend a minimum of 10-AWG ground wire.
• #10 (ERX-7xx and ERX-14xx models) or #8 (ERX-310 router) kep nut to connect the ground (earth) wire to the ground terminal.
• Power input module wiring—We recommend a minimum of 8-AWG wire for ERX-14xx models, 12-AWG wire for ERX-7xx models, and 14-AWG wire for ERX-310 routers (DC model) with a dual stud terminal lug with 5/8–inch spacing. For the ERX-310 router AC model, use a standard IEC power cord.

  Consider the distance from the connection point and the configuration of the system when determining the size of wire used.

  See System Specifications for more information on router specifications.

  Table 7: Required Cables

  Connection	Port and Cable Used
  Management connection between SRP I/O module and the LAN	One 10/100Base-T Ethernet management port with an RJ-45 connector
  Management connection between SRP I/O module and a management console	One RS-232 port with a DB-9 connector for VT100 management access
  Direct connections to I/O modules	See the ERX Module Guide for specific I/O module connector information

  Note: If you plan to use a cable-management bracket (ERX-7xx and ERX-14xx models only), install it before you begin cabling your router. Cable-management brackets are helpful to keep network interface cables untangled and orderly and to prevent cables from hindering access to other slots. See Installing a Cable-Management Bracket on ERX-7xx Models.

Copyright © 2008, Juniper Networks, Inc. All Rights Reserved. Trademark Notice.