Configuring PPPoE over a Static Ethernet Interface

To configure PPPoE over an Ethernet interface:

1. Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.

   host1(config)#interface fastEthernet 4/1

2. Specify PPPoE as the encapsulation method on the interface.

   host1(config-if)#pppoe

3. Create a PPPoE subinterface.

   host1(config-if)#pppoe subinterface fastEthernet 4/1.1

4. Specify PPP as the encapsulation method on the interface.

   host1(config-if)#encapsulation ppp

5. Assign an IP address and mask.

   host1(config-if)#ip address 164.10.6.51 255.255.255.0

6. (Optional) Configure additional PPPoE subinterfaces by completing Steps 3 through 5 using unique numbering.

Figure 10 illustrates this configuration.

Figure 10: Example of PPPoE Stacking Configuration Procedure

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.