policy Objects

Table 28 presents policy objects you can configure using the bulkstats schema subtree command.

Table 28: Schema Policy Objects

bulkstats schema

• Use to create the schema for collecting bulk statistics.
• Example

  host1(config)#bulkstats schema 4

• Use the no version to delete the specified schema.

  Note: If you create a collector but there is no schema for that collector, the collector will not be active, and a schema will be created automatically for that collector to collect if-stats for all subtree attributes.

• See bulkstats schema.

bulkstats schema subtree

• Use to set the schema for collecting data. Specify one of the following keywords:
  • if-stack—Retrieves the interface and interface column configuration.
  • if-stats—Retrieves interface usage data on sets of interface types; using the subtreelist keyword along with the if-stats keyword lets you specify specific counters and lets you set the time-offset parameter; using the if-create-delete-time-stats keyword along with the if-stats keyword retrieves interface final statistics (interface statistics that may be lost during higher create or delete frequency) on a per-interface basis.
  • igmp—Retrieves IGMP usage data; using the subtreelist keyword along with the igmplist keyword lets you obtain statistics for one or more specific IGMP lists.
  • policy—Retrieves policy usage data.
  • system—Retrieves global system and per-module statistics and information.
• Example 1

  host1(config)#bulkstats schema 1 subtree if-stats subtreelist lower-interface

• Example 2

  host1(config)#bulkstats schema 5 subtree if-stats if-create-delete-time-stats interfaceType ?

    atm1483     Configure bulkstats for ATM 1483 sub-interfaces
    ip          Configure bulkstats for IP interfaces
    mplsL2Shim  Configure bulkstats for MPLS shim Interfaces
    mplsMajor   Configure bulkstats for MPLS major Interfaces
    mplsMinor   Configure bulkstats for MPLS minor Interfaces
    ppp         Configure bulkstats for PPP interfaces
    vlan        Configure bulkstats for VLAN Sub-Interfaces

• Use to collect statistics on a specified policy, a policy type, or based on color-coded tags applied by a policy. Specify one of the following keywords:
  • policy-name—Collects statistics for a specified policy
  • policy-type—Collects data on input policies, local input policies, output policies, or secondary output policies
  • policy-subtreelist—Collects statistics based on color-coded tags applied by a policy
• You create policies using the policy-list command. See JUNOSe Policy Management Configuration Guide .
• Example

  host1(config)#bulkstats schema 4 subtree policy policy-name XMYpolicy

• Use the no version to delete the specified schema.
• See bulkstats schema subtree.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.