Managing Line Module Redundancy

When the router is running and a redundancy group is installed, you can manage the redundancy situation as follows:

• Force switchover manually.
• Force reversion manually.

redundancy force-switchover

• Use to force the router to switch from the primary line module in the specified slot or the primary SRP module to the spare line module or SRP module.
• The command causes a single switchover. When you reboot, the router reverts to the configured setting for this slot.
• The redundancy force-switchover command overrides the redundancy lockout command.
• Example

  host1#redundancy force-switchover 5

• There is no no version.
• See redundancy force-switchover.

redundancy revert

• Use to force the router to revert to the primary line module in the specified slot.
• The router acts on this command immediately unless you specify a time or a time and date that the action is to take place.
• The command causes a single reversion. When you reboot, the router uses the configured setting for this slot.
• Example

  host1#redundancy revert 4 23:00:00 5 September 200X

• There is no no version.
• See redundancy revert.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.