Enabling and Disabling the Resource Threshold Monitor

You may want to set thresholds for certain interface resources on the router. The RTM allows you to specify rising and falling thresholds as well as hold-down times for certain interfaces by using the resource if-type and resource threshold commands.

resource if-type

• Use to specify rising and falling thresholds and hold-down times for certain interfaces on a slot or systemwide basis.
• Example

  host1(config)#resource if-type ip slot 4 falling 500

• Use the no version to set the threshold parameter to its default value (for rising, 90 percent of the maximum value of the resource; for falling, 1 percent of the maximum value of the resource; for hold-down time, 300 seconds).
• See resource if-type.

resource threshold

• Use to disable the issuance of trap messages when the router reaches preset threshold limits.
• Example

  host1(config)#resource threshold disable traps

• Use the no version to reenable traps for resource threshold conditions.
• See resource threshold.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.