Configuring SNMP Dynamic Groups and Views

With dynamic configurable views and groups you can fine-tune application features to a specific group, You can have 32 view entries (with distinct names) per virtual router. Because there is no limit to the number of entries within a distinct view name, you can configure complex views. You can also have 32 access entries (with distinct names) per virtual router. All views are on a per-virtual-router basis; although static views are on a per-virtual-router basis, they cannot be altered. If you modify a view, the system deletes the original entry and creates the new view. Therefore, if the new view fails, the original view is no longer available.

SNMP v3 configurations are allowed only at the maximum CLI privilege level (15).

snmp-server group

• Use to dynamically configure server groups. You must access the CLI at privilege level 15 to view or use this command.
• Example

  host1(config-profile)#snmp-server group grp1authpriv usm priv read grp1read write grp1write notify grp1notify

• Use the no version to remove the dynamically created group.
• See snmp-server group.

snmp-server view

• Use to dynamically configure an SNMP server view. You must access the CLI at privilege level 15 to view or use this command.
• Example

  host1(config)#snmp-server view view1 1.3.6.1 included non-volatile

• Use the no version to remove the dynamically created view.
• See snmp-server view.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.