Configuring Login Conditions

You can issue the dsr-detect command to configure the system so that a data set ready (DSR) signal is required to log in to the console. If a session is in progress and the DSR signal is lost, the user is logged out automatically.

DSR is carried on pin 6 of the SRP module’s RS-232 (DB-9) connector. The DSR input must be connected to the DSR output of a modem or the DTR output of another data terminal device, such as a terminal server, that supports this signal.

dsr-detect

• Use to require that a DSR signal be detected on the line for a user to log in to the console.
• By default, DSR is not required and DSR detection is disabled.
• Example

  host1(config-line)#dsr-detect

• Use the no version to remove the DSR requirement for login.
• See dsr-detect.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.