Configuring Line Module Redundancy

You can modify the default redundancy operations on the router
as follows:

• Disable automatic switchover on a slot.
• Enable automatic reversion after switchover.

redundancy lockout

• Use to prevent the router from switching automatically to a spare line module if the primary module in the specified slot fails.
• The redundancy force-switchover command overrides the redundancy lockout command.
• Example

  host1(config)#redundancy lockout 5

• Use the no version to restart redundancy protection for the slot.
• See redundancy lockout.

redundancy revertive

• Use to enable the router to revert from all spare line modules to the associated primary line modules automatically.
• Reversion takes place when the primary line module is once again available unless you specify a time of day. In that case, reversion takes place only when the primary module is available and after the specified time.
• Example

  host1(config)#redundancy revertive 23:00:00

• Use the no version to disable automatic reversion.
• See redundancy revertive.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.